Version 1.3 Manual #001011 6 Albany High Speed Doors Operation DO NOT reset the door until the break away flap(s) are out of the side rails on th eside away from Download Ultrafabric Doors W/ Ultrasmart Operation - Albany document. High Speed Doors Operation UltraSmart™ STARTUP PROCEDURE Albany’s UltraSmart™ control system is designed to accommodate numer- ous option modules and future technological advances. This manual will address necessary settings for the standard options; however, optional modules and special applications may require additional steps to be. High Speed Doors Operation UltraSmart™ STARTUP PROCEDURE Albany’s UltraSmart™ control system is designed to accommodate numer- ous option modules and future technological advances. This manual will address necessary settings for the standard options; however, optional modules and special applications may require additional steps to be.
- Albany Ultrasmart Controller Operation Manual 2017
- Albany Ultrasmart Controller Operation Manual Free
Download Owner's manual of Albany 570 Door, Garage Door Opener for Free or View it Online on All-Guides.com.
Brand: Albany
Category: Door , Garage Door Opener Beijing express email address extractor free.
Type: Owner's manual
Model: Albany 570 , Albany RapidRoll 670
Pages: 56 (2.97 Mb)
Part Number 6410T0006 Version 4/23/2010
The motor brake is located inside the fan cover compartment of the motor. It can be accessed by
removing the fan cover. Refer to Figure 28 while following this procedure.
WARNING
MAKE SURE THE DOOR IS POWERED DOWN AND LOCKD OUT BEFORE REMOVING THE
FANCOVER. THIS IS TO ASSURE THAT THE MOVING MOTOR PARTS ARE NOT EXPOSED
1.Remove the fan cover
3.Set the air gap “T” (referred to Figure 28) to 0.3mm by adjusting the screw referred to in Figure 28
4.Tighten nut (referred to in Figure 28as item 6) to lock in the gap setting.
5.Verify that the gap “X” (referred to Figure 28) is a minimum of 1.0mm by adjusting the nut shown.
Albany Ultrasmart Controller Operation Manual 2017
Perform this procedure whenever the gap “T” grows above 0.45mm.